WELCOME TO IPT, INC., PRODUCTS FOR THE STONE CARE PROFESSIONAL

Instructions for Polishing Powder
PP5X05, PP5X10, PP5X25




Equipment and Material

  1. 175 RPM Floor Machine with Hardrock Drive Plate.
  2. White Buffing Pad.
  3. PP5X00 Polishing Powder.
  4. Easy Mask Tape or plastic sheeting for masking.
  5. Wet Vac, mop, bucket, sponge, rags, etc.

Notes

  1. One (1) pound will polish approximately 200 square feet.
  2. Mix must be kept wet or etching will occur.
  3. It is best to work with two men to buff and rinse.

Instructions

  1. Strip off any wax or sealer from the marble.
  2. Sprinkle approximately 1/4 cup of the mix on to the floor to cover an area the size of the buffing pad. Sprinkle the balance around the entire area.
  3. Wet the mix with enough cool water to make a watery slurry. (Do not over wet or make watery)
  4. Place the buffing pad and machine over the mix and begin buffing the area moving the machine constantly.
  5. If mix seems too dry or pasty add water as needed.
  6. Buff the area 5 to 10 minutes checking periodically to see if the desired shine has been achieved. The second man should do this by squeegeeing back or wiping the material away in a small area.
  7. When shine is achieved flood the area with water, buff over with one more pass, stop machine and vac off the water.
  8. Immediately flood again, mop and vac off.
  9. Rinse/mop several times with clean water.