WELCOME TO IPT, INC., PRODUCTS FOR THE STONE CARE PROFESSIONAL

INSTRUCTIONS FOR HARDROCK STONE, TILE & MASONRY CLEANERS

STM4000 Stone & Tile Cleaner

PREPARATION:  Dust mop, sweep or vacuum area to remove loose dirt.

Test a small area before complete application to insure the desired results will be achieved.

APPLICATION:  Mix 3 oz. (90 ml) of cleaner per on gallon (3.785 L) of water.  For Floors:  Ring excess liquid from the mop and damp mop the floor.  Allow to air dry.  Do not rinse.  For counter tops and walls:  wipe with a cloth or sponge containing the mixed solution.

STM6000 Phosphoric Acid Cleaner

PREPARATION:  Wait a minimum of 7 days before cleaning newly grouted installations.  Mask off any adjoining surfaces that may be damaged by acid.  Use plastic or acid resistant tape.

Test a small area before complete application to insure the desired results will be achieved.

MIXING:  The ratio of acid to water will vary depending on the job to be done.  Start with a mix of 1 part acid to 5 parts water and adjust the strength as needed.

APPLICATION:  Pre-wet the surface with a light amount of water, apply the mixed acid solution and allow to stand for 1 or 2 minutes and then agitate with a brush or white scrub pad.  Do not allow the solution to dry on the surface.  Vacuum or mop up the dirty solution.  Re-wet with clean water and scrub with a brush or white pad and rinse thoroughly to insure that all of the acid solution has been removed.

MAINTENANCE:  Hardrock Stone & Tile Cleaner is recommended for regular maintenance cleaning.